Cross cut adhesion test kit cc3000

CC3300The TQC Cross Cut Adhesion Test KIT CC3000 is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or 100 similar squares. The ruled area is evaluated by using a table chart after a short treatment with a stiff brush, or adhesive tape for hard substrates.

Read more: Cross cut adhesion test kit cc3000

Cross cut adhesion test cc2000

CC2000The TQC CC2000 Cross Cut Adhesion Test KIT is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or 100 similar squares. The ruled area is evaluated by using a table chart after a short treatment with a stiff brush, or adhesive tape for hard substrates.

Read more: Cross cut adhesion test cc2000

Pull off adhesion tester model pat gm01 gm04

LD9000This Precision Pull Off Adhesion Tester is a hydraulic tensile tester that works on the so-called pull off principle, and complies with the requirements of ISO 4624. The system consists of a hydraulic hand-pump equipped with a precision manometer and the actual adhesion pull off testing head.

Read more: Pull off adhesion tester model pat gm01 gm04

Adhesion test kit hpk

HPKThe TQC Adhesion Test Kit (HPK) is a method developped in the Netherlands by FOSAG and SKH to determine the adhesion of new and old paint layers on wood and woodlike materials. The damage on the substrate will be reduced to a minimum. The adhesion is judged by comparing the removed paint on the tape, and the remaining paint on the wood with the illustrations classifying the damage from class 0 to 5. Delivery includes cutting tool and tape.The Tape For Adhesion Test can be ordered separately as well.

Read more: Adhesion test kit hpk

Adhesion test pat handy

LD9200The TQC Adhesion Test Pat Handy is an easy to use, lightweight hydraulic adhesion tester that applies an increasing level of pull off force to a dolly adhered to the surface under test simply by turning the handle. The adhesion test head has self adjusting legs, which ensure that the pull off force is always applied 90º to the coating even on uneven substrate surfaces. The self adjusting feature results in extremely accurate and reproducable adhesion test results. The TQC Adhesion Test Pat Handy weighs only 1250 gram and comes complete with an A4-size carrying 80 mm height case.

Read more: Adhesion test pat handy

Cross cut adhesion test cc1000

CC1000The TQC Cross Cut Adhesion Test KIT CC1000 is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or 100 similar squares. The ruled area is evaluated by using a table chart after a short treatment with a stiff brush, or adhesive tape for hard substrates.

Read more: Cross cut adhesion test cc1000

Adhesion tester positest at-a (at)

POSITEST AT-A (AT)Measures adhesion of coatings to metal, wood, concrete and other rigid substrates Revolutionary self-alignment feature and pull rate indicator. Conforms to national and international standards including ASTM D4541/D7234, ISO 4624/16276-1, AS/NZS 1580.408.5 and others

PDF Brochure

Read more: Adhesion tester positest at-a (at)